8

what usually works for me is this recipe - 2 parts PVA glue 2 parts gloss varnish (I use the stuff you would varnish, say, a bench with, rather than the one that Games Workshop makes) 1 part distilled water (it is important to use distilled water because you don't get the minerals from the tap into the water effects). This is thin enough so it will apply ...


6

Sealing a model means applying a coat of a transparent and durable protective layer after painting. Normally this is a clear varnish. After leaving your painted model to thoroughly dry, you brush or spray it on. This helps prevent chipping and flaking of your paint job during subsequent transportation and gaming. You have a basic choice of gloss or matte ...


5

This is not from me, but I approve it :) Skaven pros - They have access to vast arrays of troops/troop types, and can get them in vast quantities. The leadership rules they come with over-ride what would be a fatal weakness and combined with the new re-roll of all leadership tests allowed by the BSB and the general's leadership in a 24" diameter bubble ...


5

I can't answer the specific question on drill bit types. I've don plenty of magnatizing, but haven't analyzed the tools I've used in that great of depth. I've used Dremel's precision drill bit set in my 7.2 Volt rotary tool. I've never had too big a problem with the convex bottom of the hole they create. If you match the drill bit size close enough to ...


4

Since there are no pre-made "Ork Warboss Arm with Kombi-Skorcha" bits, I have decided to do a conversion myself. I will outline the steps I have taken below. Cut both the Ork Warboss Arm with the Kombi-Rokkit Launcha and a Kombi-Skorcha for Ork Nobs from the sprue and remove any excess plastic and mold lines. Cut off the front of the Rokkit Launcha, so that ...


3

Each Ripper Swarm model has 3 wounds, as per the 8th edition codex. A unit of Ripper Swarms is made up of anything from 3-9 models of Ripper Swarms. Each base is a model. Regardless of what you actually put on the model aesthetically, it will have 1 base, and that based model will have 3 wounds. So a unit composed of 3 models of Ripper Swarms would have 9 ...


Only top voted, non community-wiki answers of a minimum length are eligible